Hypertherm C107-142 Swirl Ring

Product Description

The Hypertherm C107-142 Swirl Ring is a genuine Hypertherm replacement part for Hypertherm plasma cutters.

Specifications

• Brand: Hypertherm
• Part number: C107-142
• Part description: Swirl Ring, 50/70/100 Amp
• Material: Copper
• Dimensions: 1.125" OD x 0.75" ID x 0.375" H
• Weight: 0.05 lbs

Compatibility

The Hypertherm C107-142 Swirl Ring is compatible with the following Hypertherm plasma cutters:

• Powermax30 XP
• Powermax45 XP
• Powermax65 XP
• Powermax85 XP
• Powermax105 XP
• Powermax125 XP

Installation

To install the Hypertherm C107-142 Swirl Ring, follow these steps:

1. Turn off the plasma cutter and disconnect the power cord.
2. Remove the old swirl ring by unscrewing it from the torch body.
3. Apply a small amount of anti-seize compound to the threads of the new swirl ring.
4. Screw the new swirl ring onto the torch body until it is snug.
5. Reconnect the power cord and turn on the plasma cutter.

Maintenance

The Hypertherm C107-142 Swirl Ring should be inspected regularly for wear and tear. If the swirl ring is damaged, it should be replaced immediately.

To clean the swirl ring, follow these steps:

1. Turn off the plasma cutter and disconnect the power cord.
2. Remove the swirl ring by unscrewing it from the torch body.
3. Soak the swirl ring in a mild detergent solution for 10-15 minutes.
4. Rinse the swirl ring with clean water and dry it thoroughly.
5. Reinstall the swirl ring on the torch body.

Troubleshooting

If you are experiencing problems with your Hypertherm plasma cutter, the swirl ring may be the cause. Here are some common troubleshooting tips:

• Check the swirl ring for wear and tear. If the swirl ring is damaged, it should be replaced.
• Clean the swirl ring according to the instructions in the maintenance section.
• Make sure the swirl ring is installed correctly.
• If you are still experiencing problems, contact Hypertherm customer service for assistance.

Conclusion

The Hypertherm C107-142 Swirl Ring is an important part of your Hypertherm plasma cutter. By following the installation, maintenance, and troubleshooting tips in this document, you can keep your plasma cutter running smoothly.

Similar Parts

020750
Swirl Ring 100 Amp

120252
Swirl Ring, 100 amp Oxygen, CCW

C107-283
Swirl Ring, 100 Amp, MS/SS/AL, Air

020637
100 amp swirl ring, Hypertherm HD3070

220013
Swirl Ring PAC 100 TCH

220051
PowerMax 1650 Swirl Ring 100 A

123218
Plasma, Machine and Lifter I/O, 100 ft. CABLE:37-POSN MALE/FEM DSUB 30M/100'

220553
Swirl Ring: HPR 50 amp clockwise

C107-022
Swirl Ring, 400 Amp, MS/SS/AL

220631
HPR/400 Amp/Swirl Ring/Carbon Steel