Hypertherm 220553 Swirl Ring

Product Description

The Hypertherm 220553 Swirl Ring is a genuine Hypertherm replacement part for HPR50 plasma cutters.

Specifications

• Brand: Hypertherm
• Part Number: 220553
• Description: Swirl Ring: HPR 50 amp clockwise
• Material: Copper

Compatibility

The Hypertherm 220553 Swirl Ring is compatible with the following plasma cutters:

• Hypertherm HPR50

Installation

To install the Hypertherm 220553 Swirl Ring, follow these steps:

1. Turn off the plasma cutter and disconnect the power cord.
2. Remove the old swirl ring by unscrewing it counterclockwise.
3. Apply a small amount of anti-seize to the threads of the new swirl ring.
4. Screw the new swirl ring onto the plasma cutter clockwise until it is snug.
5. Reconnect the power cord and turn on the plasma cutter.

Troubleshooting

If you are experiencing problems with your Hypertherm HPR50 plasma cutter, the swirl ring may be the cause. Here are some troubleshooting tips:

• Check the swirl ring for damage. If the swirl ring is cracked or damaged, it will need to be replaced.
• Make sure the swirl ring is installed correctly. The swirl ring should be screwed on clockwise until it is snug.
• Clean the swirl ring and the plasma cutter torch. Dirt and debris can build up on the swirl ring and cause problems.

If you have tried these troubleshooting tips and the problem persists, please contact Hypertherm customer service for assistance.

Conclusion

The Hypertherm 220553 Swirl Ring is an important part of your HPR50 plasma cutter. By following these tips, you can ensure that your swirl ring is installed correctly and is functioning properly.