Hypertherm 020637 100 Amp Swirl Ring for HD3070

Product Details

• Brand: Hypertherm
• Part number: 020637
• Description: 100 amp swirl ring for Hypertherm HD3070 plasma cutters
• Material: Copper
• Dimensions: 1.125" OD x 0.875" ID x 0.25" thick
• Weight: 0.1 lbs

Features

• Improves cut quality and reduces dross
• Extends the life of your electrode and nozzle
• Easy to install

Compatibility

• Hypertherm HD3070 plasma cutters

Installation

1. Remove the old swirl ring from the torch head.
2. Clean the torch head and the new swirl ring with a solvent.
3. Apply a small amount of anti-seize compound to the new swirl ring.
4. Thread the new swirl ring onto the torch head.
5. Tighten the swirl ring until it is snug.

Troubleshooting

If you are experiencing problems with your Hypertherm HD3070 plasma cutter, the swirl ring may be the cause. Here are some troubleshooting tips:

• Check the swirl ring for damage. If the swirl ring is damaged, it will need to be replaced.
• Make sure the swirl ring is installed correctly. The swirl ring should be seated flush against the torch head.
• Clean the swirl ring and the torch head with a solvent. Dirt and debris can cause the swirl ring to malfunction.
• If you are still experiencing problems, contact Hypertherm technical support for assistance.

Conclusion

The Hypertherm 020637 100 Amp Swirl Ring is an essential part of your Hypertherm HD3070 plasma cutter. By following these tips, you can keep your swirl ring in good condition and ensure that your plasma cutter is performing at its best.

Similar Parts

020947
50 amp swirl ring, Hypertherm HD3070

020789
70 amp swirl ring, Hypertherm HD3070

120592
100 amp retaining cap, Hypertherm HD3070

120410
100 amp electrode, Hypertherm HD3070

120273
100 amp shield, Hypertherm HD3070

120272
100 amp nozzle, Hypertherm HD3070

120112
70 amp and 50 amp electrode, Hypertherm HD3070

020949
50 amp shield cap, Hypertherm HD3070

120111
30 amp electrode, Hypertherm HD3070

120113
50 amp electrode, Hypertherm HD3070