Hypertherm 428162 KIT:DURAMAX HYAMP HAND TORCH TRIGGGER START SWITCH REPLACEMENT
Product Description
The Hypertherm 428162 KIT:DURAMAX HYAMP HAND TORCH TRIGGGER START SWITCH REPLACEMENT is a genuine Hypertherm replacement part.
Compatibility
The Hypertherm 428162 KIT:DURAMAX HYAMP HAND TORCH TRIGGGER START SWITCH REPLACEMENT is compatible with the following Hypertherm plasma cutters:
- Duramax HyAmp
Installation
To install the Hypertherm 428162 KIT:DURAMAX HYAMP HAND TORCH TRIGGGER START SWITCH REPLACEMENT, follow these steps:
- Disconnect the power supply from the plasma cutter.
- Remove the old trigger switch assembly from the hand torch.
- Install the new trigger switch assembly into the hand torch.
- Reconnect the power supply to the plasma cutter.
Troubleshooting
If the trigger switch does not work after installation, check the following:
- Make sure that the trigger switch is properly installed.
- Make sure that the trigger switch is compatible with your plasma cutter.
- Check the wiring to make sure that there are no loose or damaged connections.
If the trigger switch still does not work, contact Hypertherm customer support for assistance.
Conclusion
The Hypertherm 428162 KIT:DURAMAX HYAMP HAND TORCH TRIGGGER START SWITCH REPLACEMENT is a genuine Hypertherm replacement part that is compatible with the Duramax HyAmp plasma cutter. This part is easy to install and can be replaced in a matter of minutes.
Similar Parts
228719
KIT:DURAMAX/DURAMAX HYAMP/RT HAND TORCH CAP SENSOR SWITCH
428156
KIT:DURAMAX HYAMP/LT HAND TORCH TRIGGER/SPRING REPLACEMENT
228720
KIT:DURAMAX/DURAMAX HYAMP/MRT MACHINE TORCH CAP SENSOR SWITCH
128642
PowerMax 1250 Kit: T80 Start Switch Replacement
428278
KIT:DURAMAX HYAMP LONG TORCH 45° FRONT REPLACEMENT
228721
KIT:DURAMAX HAND TORCH TRIGGER/SPRING REPLACEMENT
228960
KIT:DURAMAX HAND TORCH LEAD REPLACEMENT 50'
420172
SHIELD:DURAMAX HYAMP 45A/65A HAND
059520
DURAMAX HYAMP 180 DEGREE MACHINE TORCH ASSEMBLY 25'
228958
KIT:DURAMAX H TORCH MAIN BODY REPLACEMENT 75°