Hypertherm 420211 SWIRL RING:DURAMAX LT

Product Description

The Hypertherm 420211 SWIRL RING:DURAMAX LT is a genuine Hypertherm replacement part. This swirl ring is designed for use with the Hypertherm Duramax LT plasma cutting torch. It is responsible for creating the swirling motion of the plasma gas, which helps to improve cut quality and reduce dross.

Specifications

• Part Number: 420211
• Brand: Hypertherm
• Description: SWIRL RING:DURAMAX LT
• Material: Copper
• Dimensions: 1.0" OD x 0.75" ID x 0.25" H
• Weight: 0.05 lbs

Compatibility

The Hypertherm 420211 SWIRL RING:DURAMAX LT is compatible with the following Hypertherm plasma cutting torches:

• Duramax LT

Installation

To install the Hypertherm 420211 SWIRL RING:DURAMAX LT, follow these steps:

1. Remove the old swirl ring from the torch.
2. Clean the torch body and the new swirl ring with a solvent.
3. Apply a small amount of anti-seize compound to the new swirl ring.
4. Thread the new swirl ring onto the torch body.
5. Tighten the swirl ring until it is snug.

Maintenance

To maintain the Hypertherm 420211 SWIRL RING:DURAMAX LT, follow these steps:

• Inspect the swirl ring for wear or damage before each use.
• Clean the swirl ring with a solvent after each use.
• Replace the swirl ring if it is worn or damaged.

Troubleshooting

If you are experiencing problems with your Hypertherm Duramax LT plasma cutting torch, the swirl ring may be the cause. Check the swirl ring for wear or damage and replace it if necessary. If you are still experiencing problems, contact Hypertherm technical support for assistance.