Hypertherm 228254 Motor/Encoder Assy w/ 50 ft cable

Product Description

The Hypertherm 228254 Motor/Encoder Assy w/ 50 ft cable is a replacement part for Hypertherm plasma cutting systems. This assembly includes a motor, encoder, and 50-foot cable. The motor is responsible for driving the cutting torch, while the encoder provides feedback to the system about the torch's position. The cable connects the motor/encoder assembly to the plasma cutting system.

Specifications

• Brand: Hypertherm
• Part number: 228254
• Part description: Motor/Encoder Assy w/ 50 ft cable
• Motor type: Brushless DC
• Encoder type: Optical
• Cable length: 50 feet

Compatibility

The Hypertherm 228254 Motor/Encoder Assy w/ 50 ft cable is compatible with the following Hypertherm plasma cutting systems:

• Powermax45XP
• Powermax65XP
• Powermax85XP
• Powermax105XP
• Powermax125XP

Installation

To install the Hypertherm 228254 Motor/Encoder Assy w/ 50 ft cable, follow these steps:

1. Disconnect the power from the plasma cutting system.
2. Remove the old motor/encoder assembly.
3. Install the new motor/encoder assembly.
4. Connect the cable to the motor/encoder assembly and the plasma cutting system.
5. Restore power to the plasma cutting system.

Troubleshooting

If you are experiencing problems with the Hypertherm 228254 Motor/Encoder Assy w/ 50 ft cable, here are some troubleshooting tips:

• Check the connections between the motor/encoder assembly and the plasma cutting system.
• Make sure that the cable is not damaged.
• Clean the motor/encoder assembly and the cable.
• If the problem persists, contact Hypertherm technical support.

Conclusion

The Hypertherm 228254 Motor/Encoder Assy w/ 50 ft cable is a critical component of Hypertherm plasma cutting systems. This assembly is responsible for driving the cutting torch and providing feedback to the system about the torch's position. By following the installation and troubleshooting tips in this document, you can ensure that your Hypertherm plasma cutting system is operating properly.