Hypertherm 123970 Cable
Part Description
CABLE:ENCODER/HALL 10.06 m (33 ft).
Compatibility
This cable is compatible with the following Hypertherm plasma cutters:
- Powermax30 XP
- Powermax45 XP
- Powermax65 XP
- Powermax85 XP
- Powermax105 XP
- Powermax125 XP
Specifications
- Length: 10.06 m (33 ft)
- Connector Type: Encoder/Hall
- Cable Type: Shielded
- AWG: 22
Installation
To install this cable, follow these steps:
- Disconnect the power supply from the plasma cutter.
- Locate the encoder/hall connector on the plasma cutter.
- Connect the encoder/hall cable to the connector.
- Reconnect the power supply to the plasma cutter.
Troubleshooting
If you are experiencing problems with this cable, check the following:
- Make sure that the cable is properly connected to the encoder/hall connector on the plasma cutter.
- Check for any damage to the cable.
- If the cable is damaged, replace it with a new one.
Similar Parts
123969
CABLE:ENCODER/HALL 7.62 m 25 ft
123971
CABLE:ENCODER/HALL 10.97 m 36 ft
223049
CABLE:ENCODER/HALL 3.2 m 10 ft
223341
CABLE:ENCODER/HALL 6.08 m 20 ft
223342
CABLE:ENCODER/HALL 10.66 m 35 ft
123899
CABLE:ENCODER/HALL 15.25 m 50 ft
Laser 04-2201:10207-01
Encoder Cable - 12m AKM 13 Feedback Cable
109483
CUR SNSR:HALL 200A 4V
109004
Current Sensor; HALL 100A=4V
228254
Motor/Encoder Assy w/ 50 ft cable