Hypertherm 220857 SWIRL RING:POWERMAX65/85

Product Description

The Hypertherm 220857 SWIRL RING:POWERMAX65/85 is a genuine Hypertherm replacement part for Powermax65 and Powermax85 plasma cutters. This swirl ring is responsible for creating the swirling motion of the plasma gas, which helps to improve the quality of the cut.

Specifications

• Brand: Hypertherm
• Part Number: 220857
• Description: SWIRL RING:POWERMAX65/85
• Material: Copper
• Dimensions: 1.125" OD x 0.75" ID x 0.25" H
• Weight: 0.05 lbs

Compatibility

The Hypertherm 220857 SWIRL RING:POWERMAX65/85 is compatible with the following Hypertherm plasma cutters:

• Powermax65
• Powermax85

Installation

To install the Hypertherm 220857 SWIRL RING:POWERMAX65/85, follow these steps:

1. Turn off the power to the plasma cutter.
2. Remove the old swirl ring by unscrewing it from the torch body.
3. Apply a small amount of anti-seize compound to the threads of the new swirl ring.
4. Screw the new swirl ring onto the torch body until it is snug.
5. Turn on the power to the plasma cutter and test the new swirl ring.

Troubleshooting

If you are experiencing problems with your Hypertherm plasma cutter, the following troubleshooting tips may help:

1. Check the swirl ring for any damage. If the swirl ring is damaged, it will need to be replaced.
2. Make sure that the swirl ring is properly installed. The swirl ring should be screwed on until it is snug.
3. Check the torch body for any damage. If the torch body is damaged, it will need to be replaced.
4. If you are still experiencing problems, contact Hypertherm customer service for further assistance.

Conclusion

The Hypertherm 220857 SWIRL RING:POWERMAX65/85 is a genuine Hypertherm replacement part that is essential for the proper operation of your Powermax65 or Powermax85 plasma cutter. By following the installation and troubleshooting tips in this document, you can ensure that your plasma cutter is operating at peak performance.