Hypertherm 120660 Nozzle Shield Assembly
Part Description
The Hypertherm 120660 nozzle shield assembly is a replacement part for Hypertherm plasma cutting torches.
Compatibility
The 120660 nozzle shield assembly is compatible with the following Hypertherm plasma cutting torches:
- Powermax30 XP
- Powermax45 XP
- Powermax65 XP
- Powermax85 XP
- Powermax105 XP
- Powermax125 XP
Installation
To install the 120660 nozzle shield assembly, follow these steps:
- Turn off the plasma cutting torch and allow it to cool down.
- Remove the old nozzle shield assembly by unscrewing it from the torch body.
- Screw the new nozzle shield assembly onto the torch body.
- Tighten the nozzle shield assembly until it is snug.
Troubleshooting
If you are experiencing problems with the 120660 nozzle shield assembly, here are some troubleshooting tips:
- Check to make sure that the nozzle shield assembly is properly installed.
- Check to make sure that the nozzle shield assembly is not damaged.
- Check to make sure that the nozzle shield assembly is clean and free of debris.
- If you are still experiencing problems, contact Hypertherm customer service for assistance.
Safety Precautions
When working with the 120660 nozzle shield assembly, be sure to follow these safety precautions:
- Wear safety glasses and protective clothing.
- Do not touch the nozzle shield assembly while it is hot.
- Be aware of the potential for electrical shock when working with the nozzle shield assembly.
- If you are unsure about any of the safety precautions, consult with a qualified professional.
Similar Parts
120727
Nozzle shield assembly
420045
SHIELD: 9430 200A AIR HYSPEED CONSUMABLES This shield is to be used with the MAXPro no...
120685
Nozzle/Shield Assem., 70A MS
120678
Nozzle/Shield Assy., 30A MS
120748
Nozzle/Shield Assem., 100A AL
120720
Nozzle/Shield Assy. 100A SST
120706
Nozzle/Shield Assem., 45A SST
120713
Nozzle/Shield Assem., 70A SS
420475
SHIELD ASSEMBLY:XPR 300 AMP NON-FERROUS WATER
420472
SHIELD ASSEMBLY:XPR 170 AMPS NON-FERROUS WATER