Hypertherm 120713 Nozzle/Shield Assembly, 70A SS

Description

The Hypertherm 120713 Nozzle/Shield Assembly is a replacement part for Hypertherm plasma cutters. It is made of stainless steel and is rated for 70 amps. The assembly includes the nozzle, shield, and retaining nut.

Specifications

• Brand: Hypertherm
• Part number: 120713
• Part description: Nozzle/Shield Assem., 70A SS
• Material: Stainless steel
• Amperage rating: 70 amps

Installation

To install the Hypertherm 120713 Nozzle/Shield Assembly, follow these steps:

1. Turn off your plasma cutter.
2. Allow the plasma cutter to cool down.
3. Remove the old nozzle and shield assembly.
4. Clean the torch body where the nozzle and shield assembly will be installed.
5. Apply a small amount of anti-seize compound to the threads of the retaining nut.
6. Screw the new nozzle assembly onto the torch body.
7. Tighten the retaining nut until it is snug.
8. Reattach the plasma cutter torch to the power supply.

Maintenance

To maintain the Hypertherm 120713 Nozzle/Shield Assembly, follow these steps:

• Inspect the nozzle and shield assembly for damage after each use.
• Replace the nozzle and shield assembly if it is damaged.
• Clean the nozzle and shield assembly with a soft cloth and mild detergent after each use.
• Store the nozzle and shield assembly in a clean, dry place.

Similar Parts

120685
Nozzle/Shield Assem., 70A MS

120706
Nozzle/Shield Assem., 45A SST

120748
Nozzle/Shield Assem., 100A AL

120711
Electrode 70A SST

120746
Electrode, 70A AL

120684
Swirl Ring, 70A MS

120683
Electrode, 70A MS

420045
SHIELD: 9430 200A AIR HYSPEED CONSUMABLES This shield is to be used with the MAXPro no...

120720
Nozzle/Shield Assy. 100A SST

120727
Nozzle shield assembly