Hypertherm 041511 PCB Assy: Command THC Motor Drive

Part Information

• Brand: Hypertherm
• Part Number: 041511
• Part Description: PCB Assy: Command THC Motor Drive

Product Description

The Hypertherm 041511 PCB Assy: Command THC Motor Drive is a printed circuit board assembly used to control the THC (torch height control) motor drive in Hypertherm plasma cutting systems. The assembly consists of a printed circuit board, a number of electronic components, and a connector for the THC motor. The assembly is responsible for receiving signals from the THC control and generating the appropriate signals to drive the THC motor.

Features

• Controls the THC motor drive in Hypertherm plasma cutting systems
• Consists of a printed circuit board, electronic components, and a connector for the THC motor
• Receives signals from the THC control and generates the appropriate signals to drive the THC motor

Applications

The Hypertherm 041511 PCB Assy: Command THC Motor Drive is used in the following Hypertherm plasma cutting systems:

• Powermax45XP
• Powermax65
• Powermax85
• Powermax105
• Powermax125

Installation

The Hypertherm 041511 PCB Assy: Command THC Motor Drive is installed in the following manner:

1. Disconnect the power supply from the plasma cutting system.
2. Remove the cover from the plasma cutting system.
3. Locate the THC motor drive assembly.
4. Remove the old THC motor drive assembly.
5. Install the new THC motor drive assembly.
6. Replace the cover on the plasma cutting system.
7. Reconnect the power supply to the plasma cutting system.

Troubleshooting

If the Hypertherm 041511 PCB Assy: Command THC Motor Drive is not functioning properly, the following troubleshooting steps can be performed:

1. Check the connections between the THC motor drive assembly and the THC control.
2. Check the connections between the THC motor drive assembly and the THC motor.
3. Check the continuity of the THC motor.
4. Check the voltage at the THC motor.
5. If the problem persists, replace the THC motor drive assembly.