Hypertherm 229653 Harness: HPR400 Pump Motor Drive Board Power Replacement

Product Description:

The Hypertherm 229653 Harness is a replacement part for the HPR400 plasma cutting system. This harness connects the pump motor drive board to the power supply, providing power to the pump motor. The harness is made of high-quality materials and is designed to withstand the harsh conditions of plasma cutting.

Specifications:

• Brand: Hypertherm
• Part Number: 229653
• Part Description: Harness: HPR400 pump motor drive board power replacement
• Length: 6 feet
• Gauge: 16 AWG
• Material: PVC
• Connectors: (1) 4-pin Molex connector, (1) 2-pin Molex connector

Installation:

To install the Hypertherm 229653 Harness, follow these steps:

1. Disconnect the power supply from the plasma cutting system.
2. Remove the old harness from the pump motor drive board and the power supply.
3. Connect the new harness to the pump motor drive board and the power supply.
4. Reconnect the power supply to the plasma cutting system.

Troubleshooting:

If you are experiencing problems with the Hypertherm 229653 Harness, check the following:

• Make sure that the harness is properly connected to the pump motor drive board and the power supply.
• Check for any damage to the harness.
• If the harness is damaged, replace it with a new one.

Conclusion:

The Hypertherm 229653 Harness is a critical component of the HPR400 plasma cutting system. This harness provides power to the pump motor, which is essential for the operation of the plasma cutting system. By following the installation and troubleshooting instructions, you can ensure that the harness is properly installed and functioning correctly.