Hypertherm 029326 Coolant Level Switch Assembly for Max200

Description

The Hypertherm 029326 Coolant Level Switch Assembly for Max200 is a replacement part for the Hypertherm Max200 plasma cutter. The assembly includes the coolant level switch, a float, and a mounting bracket. The coolant level switch is a normally closed switch that opens when the coolant level drops below a predetermined level. The float is attached to the switch and rises and falls with the coolant level. The mounting bracket attaches the switch assembly to the plasma cutter.

Specifications

• Brand: Hypertherm
• Part number: 029326
• Part description: Coolant level switch assembly for Max200
• Weight: 0.5 pounds
• Dimensions: 3 x 2 x 1 inches

Installation

To install the Hypertherm 029326 Coolant Level Switch Assembly for Max200, follow these steps:

1. Turn off the plasma cutter and disconnect the power cord.
2. Remove the old coolant level switch assembly from the plasma cutter.
3. Install the new coolant level switch assembly in the reverse order of removal.
4. Reconnect the power cord and turn on the plasma cutter.
5. Test the coolant level switch by filling the coolant reservoir to the full level. The coolant level switch should be closed (continuity) when the reservoir is full. The coolant level switch should be open (no continuity) when the reservoir is empty.

Troubleshooting

If the coolant level switch is not working properly, check the following:

• The coolant level switch is properly installed.
• The float is not damaged or obstructed.
• The mounting bracket is not damaged or loose.
• The wiring to the coolant level switch is not damaged or loose.

If the coolant level switch is still not working properly, contact Hypertherm for assistance.

Conclusion

The Hypertherm 029326 Coolant Level Switch Assembly for Max200 is a critical part of the plasma cutter. The switch assembly ensures that the plasma cutter has sufficient coolant to operate properly. By following the installation and troubleshooting steps outlined in this document, you can keep your plasma cutter running smoothly.