Hypertherm 029360 THMBWHL/POT PNL SA:MAX200

Product Description

The Hypertherm 029360 THMBWHL/POT PNL SA:MAX200 is a genuine Hypertherm replacement part. This thumbwheel/potentiometer control panel is compatible with the following Hypertherm plasma cutters:

• Powermax45XP
• Powermax65XP
• Powermax85XP
• Powermax105XP
• Powermax125XP

The 029360 THMBWHL/POT PNL SA:MAX200 is responsible for controlling the output current of the plasma cutter. This allows the operator to adjust the cutting power to match the thickness of the material being cut.

Specifications

• Part Number: 029360
• Brand: Hypertherm
• Description: THMBWHL/POT PNL SA:MAX200
• Compatibility: Powermax45XP, Powermax65XP, Powermax85XP, Powermax105XP, Powermax125XP
• Function: Controls the output current of the plasma cutter

Installation

To install the 029360 THMBWHL/POT PNL SA:MAX200, follow these steps:

1. Disconnect the power from the plasma cutter.
2. Remove the front panel of the plasma cutter.
3. Locate the old thumbwheel/potentiometer control panel.
4. Remove the old control panel by disconnecting the wires and unscrewing the mounting screws.
5. Install the new control panel by connecting the wires and screwing in the mounting screws.
6. Replace the front panel of the plasma cutter.
7. Reconnect the power to the plasma cutter.

Troubleshooting

If the 029360 THMBWHL/POT PNL SA:MAX200 is not working properly, check the following:

• Make sure that the control panel is properly installed and that all of the wires are connected correctly.
• Make sure that the plasma cutter is receiving power.
• Check the output current of the plasma cutter. If the output current is not correct, adjust the thumbwheel/potentiometer control.
• If the problem persists, contact Hypertherm for assistance.

Conclusion

The Hypertherm 029360 THMBWHL/POT PNL SA:MAX200 is a genuine Hypertherm replacement part that is essential for controlling the output current of the plasma cutter. This part is easy to install and can be replaced in a matter of minutes. If you are experiencing problems with your plasma cutter, be sure to check the thumbwheel/potentiometer control panel and replace it if necessary.

Similar Parts

229827
ASSY:INT OPR PNL EDGE CONNECT PCB

020415
ELECTRODE:MAX200/HSD/HyPro2000/MAXPRO200 100A H35-130A H35-130A N2-200AH35-200A N2

020448
Shld: MAX200 MCHTCH 100A

023336
Interface Cable, PS to Machine, 75 ft. Max200

029326
Coolant level switch assembly for Max200

041145
PCB ASSY:MAX200 I/O

041536
PCB ASSY:MAX200/HT4X00/HD LED

120584
Torch main body -- HT2000/Max200

128789
Chopper for Max200 old part 129118

228956
KIT: PREVENTIVE MAINTENANCE YEAR1 MAX200 HyPro2000 TORCH