Hypertherm 005094 PUSH BUTTON SWITCH: TORCH
Product Description
The Hypertherm 005094 PUSH BUTTON SWITCH: TORCH is a genuine Hypertherm replacement part. It is a momentary contact switch that is used to control the torch on a Hypertherm plasma cutting system. The switch is rated for 10 amps at 125 volts AC.
Features
- Genuine Hypertherm replacement part
- Momentary contact switch
- Rated for 10 amps at 125 volts AC
- Easy to install
Compatibility
The Hypertherm 005094 PUSH BUTTON SWITCH: TORCH is compatible with the following Hypertherm plasma cutting systems:
- Powermax30 XP
- Powermax45 XP
- Powermax65 XP
- Powermax85 XP
- Powermax105 XP
- Powermax125 XP
Installation
The Hypertherm 005094 PUSH BUTTON SWITCH: TORCH is easy to install. Simply remove the old switch and replace it with the new one. Be sure to connect the wires correctly.
Troubleshooting
If the Hypertherm 005094 PUSH BUTTON SWITCH: TORCH is not working, check the following:
- Make sure that the switch is properly installed.
- Check the wires to make sure that they are connected correctly.
- Check the switch for continuity.
If the switch is still not working, it may need to be replaced.
Conclusion
The Hypertherm 005094 PUSH BUTTON SWITCH: TORCH is an important part of your Hypertherm plasma cutting system. It is a reliable and durable switch that will provide years of trouble-free service.
Similar Parts
005121
PUSH BUTTON SWITCH: GREEN 2 NO ILLUMINATE
005122
Off Red button for power supply
015634
ADPTR:1/8 NPT X 1/4 PUSH-IN
006152
CHECK VALVE:8MM PUSH-IN 1/8" MALE NATIONAL PIPE THREAD
229342
ADAPTER SUBASSEMBLY:RH 'A' FEM X 1/4 PUSH-IN
229341
ADAPTER SUBASSEMBLY:LH 'A' FEM X 1/4 PUSH-IN
015635
ADPTR:1/8 NPT X 1/4 PUSH-IN TEE
015636
ADPTR:1/8 NPT X 1/4 PUSH-IN 90
428162
KIT:DURAMAX HYAMP HAND TORCH TRIGGGER START SWITCH REPLACEMENT
228720
KIT:DURAMAX/DURAMAX HYAMP/MRT MACHINE TORCH CAP SENSOR SWITCH