Hypertherm 229918 Solenoid Valve Installation Tool

Part number: 229918

Part description: Solenoid Valve Installation Tool for 006155

Brand: Hypertherm

This tool is used to install the solenoid valve (part number 006155) on Hypertherm plasma cutters.

Installation instructions:

1. Disconnect the power supply from the plasma cutter.
2. Remove the old solenoid valve.
3. Clean the area around the solenoid valve mounting hole.
4. Apply a small amount of thread sealant to the threads of the new solenoid valve.
5. Screw the new solenoid valve into the mounting hole.
6. Tighten the solenoid valve until it is snug.
7. Reconnect the power supply to the plasma cutter.

Similar Parts

229917
TOOL ASSEMBLY:006151 SOLENOID VALVE INSTALLATION TOO

006109
Solenoid Valve for HPR/HD4070 for an Off Valve Assembly SV1 and SV2, SV4-SV9, SV11-SV16

229965
SOLENOID VALVE:06151 XPR CONSOLE SELECTION VALVE TESTED

806410
Installation and Setup Manual for Hypertherm Touchscreen Shape Cutting Controls

027347
Tool Water Tube

008197
Tool: amp pin/socket extracting

004555
Tool to remove PAC 186 torch consumables

006100
Solenoid Valve 150# 1/8 FPT Pin

006155
SOLENOID VALVE:MANIFOLD 10MM 24 VOLTS DIRECT CURRENT 3-WAY

006135
SOLENOID VALVE:150# MANIFOLD 110 VOLT 3WNC