Hypertherm 806410 Installation and Setup Manual

Overview

This document provides instructions on how to install and set up the Hypertherm Touchscreen Shape Cutting Controls.

Prerequisites

Before you begin, ensure that you have the following:

• A computer with a USB port
• A USB cable
• The Hypertherm Touchscreen Shape Cutting Controls software
• The Hypertherm Touchscreen Shape Cutting Controls documentation

Installation

1. Connect the USB cable to the computer and the Hypertherm Touchscreen Shape Cutting Controls.
2. Power on the Hypertherm Touchscreen Shape Cutting Controls.
3. The computer will detect the Hypertherm Touchscreen Shape Cutting Controls and install the necessary drivers.
4. Once the drivers are installed, the Hypertherm Touchscreen Shape Cutting Controls software will launch automatically.

Setup

1. Follow the on-screen instructions to set up the Hypertherm Touchscreen Shape Cutting Controls.
2. Once the setup is complete, you can begin using the Hypertherm Touchscreen Shape Cutting Controls.

Troubleshooting

If you experience any problems with the Hypertherm Touchscreen Shape Cutting Controls, refer to the documentation or contact Hypertherm technical support.