Hypertherm 229844 Regulator Subassembly

Part Description

The Hypertherm 229844 regulator subassembly is a water preset regulator that is used to control the water pressure in a water-cooled plasma cutting system. The regulator is preset to 35 pounds per square inch (psi) and has a 1/4" national pipe thread (NPT) inlet and outlet. The regulator is made of brass and has a Buna-N diaphragm.

Features

• Preset to 35 psi
• 1/4" NPT inlet and outlet
• Brass construction
• Buna-N diaphragm

Applications

The Hypertherm 229844 regulator subassembly can be used in a variety of water-cooled plasma cutting applications, including:

• Plasma cutting
• Laser cutting
• Waterjet cutting

Installation

The Hypertherm 229844 regulator subassembly can be installed by following these steps:

1. Turn off the water supply to the plasma cutting system.
2. Disconnect the water inlet and outlet hoses from the regulator.
3. Remove the old regulator from the plasma cutting system.
4. Install the new regulator in the plasma cutting system.
5. Reconnect the water inlet and outlet hoses to the regulator.
6. Turn on the water supply to the plasma cutting system.

Troubleshooting

If the Hypertherm 229844 regulator subassembly is not working properly, there are a few things that you can check:

• Check the water pressure at the inlet and outlet of the regulator. The pressure should be 35 psi.
• Check the diaphragm for leaks. If the diaphragm is leaking, it will need to be replaced.
• Check the regulator for clogs. If the regulator is clogged, it will need to be cleaned.

If you are still having problems with the Hypertherm 229844 regulator subassembly, you can contact Hypertherm customer service for assistance.

Conclusion

The Hypertherm 229844 regulator subassembly is a reliable and easy-to-use regulator that can be used in a variety of water-cooled plasma cutting applications. The regulator is preset to 35 psi and has a 1/4" NPT inlet and outlet. The regulator is made of brass and has a Buna-N diaphragm.