Hypertherm 229238 Start Circuit Board

Product Details

• Brand: Hypertherm
• Part Number: 229238
• Part Description: Start Circuit Board
• Weight: 0.5 lbs
• Dimensions: 6" x 4" x 2"

Features

• Controls the starting and stopping of the plasma arc
• Provides overcurrent protection for the plasma torch
• Includes a built-in air filter
• Easy to install and maintain

Compatibility

The Hypertherm 229238 Start Circuit Board is compatible with the following Hypertherm plasma cutters:

• Powermax30XP
• Powermax45XP
• Powermax65XP
• Powermax85XP
• Powermax105XP

Installation

The Hypertherm 229238 Start Circuit Board can be installed by following these steps:

1. Disconnect the power supply from the plasma cutter.
2. Remove the side panel of the plasma cutter.
3. Locate the old start circuit board and remove it.
4. Install the new start circuit board.
5. Replace the side panel of the plasma cutter.
6. Reconnect the power supply to the plasma cutter.

Maintenance

The Hypertherm 229238 Start Circuit Board requires minimal maintenance. However, it is important to keep the board clean and free of dust and debris. The board can be cleaned with a soft brush or a can of compressed air.

Troubleshooting

If the Hypertherm 229238 Start Circuit Board is not working properly, there are a few things you can check:

• Check the power supply to the plasma cutter.
• Check the connections between the start circuit board and the plasma torch.
• Check the air filter on the start circuit board.
• Check the fuses on the start circuit board.

If you have checked all of these things and the start circuit board is still not working, you may need to replace it.