Hypertherm 229229 Solenoid Valve Subassembly: HPR/HSD

Product Description

The Hypertherm 229229 Solenoid Valve Subassembly is a critical component of the HPR and HSD plasma cutting systems. This subassembly controls the flow of gas and water to the plasma torch, ensuring optimal cutting performance.

Features

• Direct acting solenoid valve
• Normally closed
• Brass body
• Stainless steel plunger
• Viton seals

Specifications

• Voltage: 24 VDC
• Current: 0.5 A
• Pressure: 150 psi (10.3 bar)
• Temperature: -40°F to 180°F (-40°C to 82°C)

Applications

The Hypertherm 229229 Solenoid Valve Subassembly is used in the following Hypertherm plasma cutting systems:

• HPR260XD
• HPR400XD
• HPR600XD
• HSD130
• HSD200

Installation

The Hypertherm 229229 Solenoid Valve Subassembly is installed in the plasma torch body. The subassembly is connected to the gas and water supply lines, and the electrical leads are connected to the power supply.

Maintenance

The Hypertherm 229229 Solenoid Valve Subassembly should be inspected regularly for signs of wear or damage. The subassembly should be cleaned and serviced as needed.

Troubleshooting

If the Hypertherm 229229 Solenoid Valve Subassembly is not functioning properly, the following troubleshooting steps can be performed:

1. Check the gas and water supply lines for leaks.
2. Check the electrical connections to the subassembly.
3. Clean the subassembly and inspect for signs of wear or damage.
4. Replace the subassembly if necessary.

Ordering Information

The Hypertherm 229229 Solenoid Valve Subassembly can be ordered through authorized Hypertherm distributors.