Hypertherm 228465 KIT:HARNNESS EDGE PRO POWER SWITCH

Product Description

The Hypertherm 228465 KIT:HARNNESS EDGE PRO POWER SWITCH is a genuine Hypertherm replacement part for your plasma cutting system. This kit includes the following components:

• Power switch
• Harness
• Mounting hardware

The power switch is used to turn the plasma cutting system on and off. The harness connects the power switch to the plasma cutting system. The mounting hardware is used to secure the power switch and harness to the plasma cutting system.

This kit is compatible with the following Hypertherm plasma cutting systems:

• Powermax45 XP
• Powermax65 XP
• Powermax85 XP
• Powermax105 XP
• Powermax125 XP

Installation

To install the Hypertherm 228465 KIT:HARNNESS EDGE PRO POWER SWITCH, follow these steps:

1. Disconnect the power supply from the plasma cutting system.
2. Remove the old power switch and harness from the plasma cutting system.
3. Install the new power switch and harness.
4. Secure the power switch and harness to the plasma cutting system using the mounting hardware.
5. Reconnect the power supply to the plasma cutting system.

Troubleshooting

If you are experiencing problems with the Hypertherm 228465 KIT:HARNNESS EDGE PRO POWER SWITCH, check the following:

• Make sure that the power switch is properly installed.
• Make sure that the harness is properly connected to the power switch and the plasma cutting system.
• Make sure that the mounting hardware is properly tightened.
• If the problem persists, contact Hypertherm technical support for assistance.

Conclusion

The Hypertherm 228465 KIT:HARNNESS EDGE PRO POWER SWITCH is a genuine Hypertherm replacement part that is essential for the safe and proper operation of your plasma cutting system. If you are experiencing problems with the power switch or harness, be sure to replace them with genuine Hypertherm parts.