Hypertherm 428047

Part description

KIT:EDGE PRO TI 24VDC CONNECTOR

Compatibility

This part is compatible with the following Hypertherm systems:

• Powermax45XP
• Powermax65XP
• Powermax85XP
• Powermax105XP
• Powermax125XP

Specifications

• Voltage: 24VDC
• Current: 10A
• Connector type: M12
• Cable length: 6 ft.

Installation

To install this part, follow these steps:

1. Disconnect the power supply from the plasma cutter.
2. Remove the old connector from the plasma cutter.
3. Connect the new connector to the plasma cutter.
4. Reconnect the power supply to the plasma cutter.

Troubleshooting

If you are experiencing problems with this part, please refer to the following troubleshooting steps:

1. Check the connections to make sure that they are secure.
2. Check the voltage and current to make sure that they are within the specified range.
3. If the problem persists, contact Hypertherm technical support.

Warranty

This part is covered by a one-year warranty. If the part fails within one year of purchase, it will be replaced free of charge.

Similar Parts

428046
KIT:EDGE PRO TI EMERGENCY STOP CONNECTOR

228493
KIT:EDGE PRO SERIAL CONNECTOR

428305
KIT:EDGE PRO/MICROEDGE PRO SERCOS PCI SLOT

003239
RELAY:SAFETY 3 NO 1 NC. 24VDC

006128
SOLENOID VALVE: 115# 24VDC NC MANIFOLD

006167
SOL VALVE:115# 24VDC NC MANIFOND SLOTTED

031148
MOTOR:24VDC 4000 RPM NEMA 23 WITH BRAKE/ENDCODER

228490
KIT:PICOPATH I/O CONNECTOR

228491
KIT:HYPATH SERVO CONNECTOR

128880
HPR quick disconnect o-ring and connector kit