Hypertherm 220997 SWL RNG:DURAMAX HYAMP
Part Description
This is a SWL RNG:DURAMAX HYAMP for Hypertherm plasma cutters.
Compatibility
This part is compatible with the following Hypertherm plasma cutters:
- Powermax30 XP
- Powermax45 XP
- Powermax65 XP
- Powermax85 XP
- Powermax105 XP
- Powermax125 XP
Installation
To install this part, follow these steps:
- Turn off the plasma cutter and disconnect the power cord.
- Remove the side panel of the plasma cutter.
- Locate the SWL RNG:DURAMAX HYAMP.
- Remove the old SWL RNG:DURAMAX HYAMP.
- Install the new SWL RNG:DURAMAX HYAMP.
- Replace the side panel of the plasma cutter.
- Reconnect the power cord and turn on the plasma cutter.
Troubleshooting
If you are experiencing problems with the SWL RNG:DURAMAX HYAMP, check the following:
- The SWL RNG:DURAMAX HYAMP is properly installed.
- The SWL RNG:DURAMAX HYAMP is not damaged.
- The plasma cutter is properly grounded.
- The plasma cutter is receiving the correct voltage.
If you are still experiencing problems, contact Hypertherm technical support.
Part Number
The part number for this SWL RNG:DURAMAX HYAMP is 220997.
Ordering Information
This part can be ordered from Hypertherm or from your local Hypertherm dealer.
Warranty
This part is covered by a one-year warranty.
Similar Parts
120783
SWL RNG:HT4400 100A OXY CW HT4400 CONSUMABLE
120179
SWL RNG: HT2000 50A OXY
220488
SWL RNG:HSD 130A
220442
SWL RNG:HPR 260A MS CCW
220305
SWL RNG:HPR 130A MS CCW
220350
SWL RNG:HPR 200A MS CCW
228720
KIT:DURAMAX/DURAMAX HYAMP/MRT MACHINE TORCH CAP SENSOR SWITCH
228719
KIT:DURAMAX/DURAMAX HYAMP/RT HAND TORCH CAP SENSOR SWITCH
420168
SHIELD:DURAMAX HYAMP 45A/65A MECHANIZED
420152
SHIELD:DURAMAX HYAMP FINECUT