Hypertherm 220747 CAP:HPR400 130A SHIELD RETAINER
Product Description
The Hypertherm 220747 CAP:HPR400 130A SHIELD RETAINER is a genuine Hypertherm replacement part. It is made of high-quality materials and is designed to withstand the harsh conditions of plasma cutting.
This shield retainer is compatible with the following Hypertherm plasma cutters:
- Powermax45XP
- Powermax65
- Powermax85
- Powermax105
- Powermax125
Features
- High-quality materials for long life
- Designed to withstand the harsh conditions of plasma cutting
- Easy to install
Benefits
- Keeps your plasma cutter running smoothly
- Prevents damage to your plasma cutter
- Saves you money on repairs
Installation
To install the Hypertherm 220747 CAP:HPR400 130A SHIELD RETAINER, follow these steps:
- Turn off your plasma cutter and disconnect the power cord.
- Remove the old shield retainer.
- Clean the area around the shield retainer.
- Apply a small amount of grease to the new shield retainer.
- Install the new shield retainer.
- Tighten the screws that hold the shield retainer in place.
- Reconnect the power cord and turn on your plasma cutter.
Troubleshooting
If you are having problems with your Hypertherm 220747 CAP:HPR400 130A SHIELD RETAINER, here are some troubleshooting tips:
- Check the shield retainer for damage. If it is damaged, replace it.
- Make sure that the shield retainer is properly installed.
- Clean the area around the shield retainer.
- If you are still having problems, contact Hypertherm customer support.
Similar Parts
220783
CAP:HPR400 400A NOZZLE RETAINER MS COUNTER-CLOCKWISE
220757
CAP:HPR400 200A NOZZLE RETAINER MS CLOCKWISE
220742
SHIELD:HPR400 130A BEVEL MS
420200
CAP:XPR SHIELD RETAINER
020415
ELECTRODE:MAX200/HSD/HyPro2000/MAXPRO200 100A H35-130A H35-130A N2-200AH35-200A N2
220996
CAP:HPRXD 80A BEVEL NOZZLE RETAINER MS CCW
420365
CAP:XPR NOZZLE RETAINER
220814
CAP:HPR/HDi 60AMP NOZZLE RETAINER
220739
CAP:HPR400 260A BEVEL NOZZLE RETAINING SS
220794
CAP:HPR400 260A BEVEL NOZZLE RET MS COUNTER-CLOCKWISE