Hypertherm 220814 CAP:HPR/HDi 60AMP NOZZLE RETAINER

Part Information

• Brand: Hypertherm
• Part Number: 220814
• Description: CAP:HPR/HDi 60AMP NOZZLE RETAINER

Product Details

The Hypertherm 220814 CAP:HPR/HDi 60AMP NOZZLE RETAINER is a genuine Hypertherm replacement part.

Compatibility

The Hypertherm 220814 CAP:HPR/HDi 60AMP NOZZLE RETAINER is compatible with the following Hypertherm plasma cutters:

• Powermax30 XP
• Powermax45 XP
• Powermax65 XP
• Powermax85 XP
• Powermax105 XP

Installation

To install the Hypertherm 220814 CAP:HPR/HDi 60AMP NOZZLE RETAINER, follow these steps:

1. Disconnect the power supply from the plasma cutter.
2. Remove the old nozzle retainer.
3. Install the new nozzle retainer.
4. Reconnect the power supply to the plasma cutter.

Troubleshooting

If you are experiencing problems with the Hypertherm 220814 CAP:HPR/HDi 60AMP NOZZLE RETAINER, please refer to the following troubleshooting tips:

• Check the nozzle retainer for damage.
• Make sure the nozzle retainer is properly installed.
• Clean the nozzle retainer and the nozzle.
• If the problem persists, contact Hypertherm technical support for assistance.

Conclusion

The Hypertherm 220814 CAP:HPR/HDi 60AMP NOZZLE RETAINER is a genuine Hypertherm replacement part that is essential for maintaining the performance of your Hypertherm plasma cutter.