Hypertherm 220353 200 Amp Swirl Ring
Product Description
The Hypertherm 220353 200 Amp Swirl Ring is a genuine Hypertherm replacement part. This swirl ring is used on the following Hypertherm plasma cutters:
- Powermax30 XP
- Powermax45 XP
- Powermax65 XP
- Powermax85 XP
The swirl ring is a consumable part that should be replaced when it becomes worn or damaged. A worn or damaged swirl ring can cause the plasma arc to become unstable, which can lead to poor cut quality and reduced productivity.
Specifications
- Part Number: 220353
- Amperage: 200
- Material: Copper
Installation
- Turn off the plasma cutter and disconnect the power cord.
- Allow the plasma cutter to cool down completely.
- Remove the old swirl ring by unscrewing it from the torch body.
- Screw the new swirl ring onto the torch body.
- Tighten the swirl ring until it is snug.
- Reconnect the power cord and turn on the plasma cutter.
Troubleshooting
If you are experiencing problems with your Hypertherm plasma cutter, the swirl ring may be the cause. Here are some troubleshooting tips:
- Check the swirl ring for wear or damage. If the swirl ring is worn or damaged, it should be replaced.
- Make sure the swirl ring is properly installed. The swirl ring should be screwed on tightly to the torch body.
- If you are still experiencing problems, contact Hypertherm technical support for assistance.
Conclusion
The Hypertherm 220353 200 Amp Swirl Ring is a critical part of your Hypertherm plasma cutter. By following these simple tips, you can keep your swirl ring in good condition and ensure that your plasma cutter is operating properly.
Similar Parts
020679
200 Amp Air/Air swirl ring HT2000
020604
Swirl Ring, O2, 200 Amp
C107-259
Swirl Ring, 200 Amp, SS, H17
C107-143
Swirl Ring, 200 Amp, MS/SS/AL
120853
Swirl Ring, N2, 200/400 Amp
220236
Hy-Speed 200 Amp Swirl Ring
C107-138
Swirl Ring, 30 Amp, SS, Air
C107-022
Swirl Ring, 400 Amp, MS/SS/AL
220631
HPR/400 Amp/Swirl Ring/Carbon Steel
C107-283
Swirl Ring, 100 Amp, MS/SS/AL, Air