Hypertherm 141368 PRINTED CIRCUIT BOARD ASSEMBLY:XPR OHMIC CONTROL
Overview
The Hypertherm 141368 PRINTED CIRCUIT BOARD ASSEMBLY:XPR OHMIC CONTROL is a critical component of the XPR plasma cutting system. It is responsible for controlling the ohmic voltage of the plasma arc, which is essential for maintaining a stable and consistent cut. The board is also responsible for monitoring the system's current and voltage, as well as for providing fault protection for the system.
Specifications
The Hypertherm 141368 PRINTED CIRCUIT BOARD ASSEMBLY:XPR OHMIC CONTROL has the following specifications:
- Input voltage: 24 VDC
- Input current: 10 A
- Output voltage: 0-10 VDC
- Output current: 10 A
- Fault protection: Overvoltage, undervoltage, overcurrent, short circuit
Installation
The Hypertherm 141368 PRINTED CIRCUIT BOARD ASSEMBLY:XPR OHMIC CONTROL is installed in the control cabinet of the XPR plasma cutting system. The board is mounted to a chassis using four screws. The board is connected to the system's power supply, the plasma torch, and the control panel using a variety of cables.
Operation
The Hypertherm 141368 PRINTED CIRCUIT BOARD ASSEMBLY:XPR OHMIC CONTROL operates by monitoring the system's current and voltage and adjusting the ohmic voltage of the plasma arc accordingly. The board also provides fault protection for the system by shutting down the system in the event of an overvoltage, undervoltage, overcurrent, or short circuit.
Troubleshooting
If the Hypertherm 141368 PRINTED CIRCUIT BOARD ASSEMBLY:XPR OHMIC CONTROL is not functioning properly, the following troubleshooting steps can be performed:
- Check the input voltage and current to the board.
- Check the output voltage and current of the board.
- Check the fault protection circuits of the board.
- If the board is still not functioning properly, it may need to be replaced.
Conclusion
The Hypertherm 141368 PRINTED CIRCUIT BOARD ASSEMBLY:XPR OHMIC CONTROL is a critical component of the XPR plasma cutting system. The board is responsible for controlling the ohmic voltage of the plasma arc to maintain a stable and consistent cut, and It is important to ensure that the board is installed and operating properly to maintain the system's performance.
Similar Parts
428750
KIT:XPR CONTROL PRINTED CIRCUIT BOARD ASSEMBLY WITH WIFI TAG
041938
PRINTED CIRCUIT BOARD ASSEMBLY:HSD CONTROL
428167
KIT:MAXPRO200 CONTROL PRINTED CIRCUIT BOARD ASSEMBLY
228577
KIT:PRINTED CIRCUIT BOARD ASSEMBLY THC CONTROL INTERFACE
228460
KIT:PRINTED CIRCUIT BOARD ASSEMBLY 230V SURGE BOARD
141371
PRINTED CIRCUIT BOARD ASSEMBLY:XPR INPUT/OUTPUT
141354
PRINTED CIRCUIT BOARD ASSEMBLY:XPR HIGH FREQUENCY HIGH VOLTAGE IGNITION
141425
PRINTED CIRCUIT BOARD ASSEMBLY:XPR POWER DISTRIBUTION
141384
PRINTED CIRCUIT BOARD ASSEMBLY:XPR FAN POWER DISTRIBUTION
228580
KIT:PRINTED CIRCUIT BOARD ASSEMBLY LIFTER INTERFACE