Hypertherm 141354 PRINTED CIRCUIT BOARD ASSEMBLY:XPR HIGH FREQUENCY HIGH VOLTAGE IGNITION

Product Description

The Hypertherm 141354 PRINTED CIRCUIT BOARD ASSEMBLY:XPR HIGH FREQUENCY HIGH VOLTAGE IGNITION is a genuine Hypertherm replacement part.

Compatibility

This part is compatible with the following Hypertherm plasma cutters:

• XPR300
• XPR300 SYNC
• XPR1750
• XPR1750 SYNC
• XPR2500
• XPR2500 SYNC

Installation

To install the 141354 PRINTED CIRCUIT BOARD ASSEMBLY:XPR HIGH FREQUENCY HIGH VOLTAGE IGNITION, follow these steps:

1. Disconnect the power supply from the plasma cutter.
2. Remove the side panel of the plasma cutter.
3. Locate the old PRINTED CIRCUIT BOARD ASSEMBLY:XPR HIGH FREQUENCY HIGH VOLTAGE IGNITION.
4. Remove the old PRINTED CIRCUIT BOARD ASSEMBLY:XPR HIGH FREQUENCY HIGH VOLTAGE IGNITION by disconnecting the wires and unscrewing the mounting screws.
5. Install the new 141354 PRINTED CIRCUIT BOARD ASSEMBLY:XPR HIGH FREQUENCY HIGH VOLTAGE IGNITION by connecting the wires and screwing in the mounting screws.
6. Replace the side panel of the plasma cutter.
7. Reconnect the power supply to the plasma cutter.

Troubleshooting

If you are experiencing problems with the 141354 PRINTED CIRCUIT BOARD ASSEMBLY:XPR HIGH FREQUENCY HIGH VOLTAGE IGNITION, here are some troubleshooting tips:

• Check the connections between the PRINTED CIRCUIT BOARD ASSEMBLY:XPR HIGH FREQUENCY HIGH VOLTAGE IGNITION and the other components of the plasma cutter.
• Make sure that the PRINTED CIRCUIT BOARD ASSEMBLY:XPR HIGH FREQUENCY HIGH VOLTAGE IGNITION is properly seated in its slot.
• If the PRINTED CIRCUIT BOARD ASSEMBLY:XPR HIGH FREQUENCY HIGH VOLTAGE IGNITION is damaged, replace it with a new one.