Hypertherm 127154 Drive Nut

Part Description

The Hypertherm 127154 drive nut is a precision-machined component that is used to connect the drive motor to the lead screw in a Hypertherm plasma cutting system. The drive nut is made of high-quality steel and is heat-treated for durability. It has a knurled surface for a secure grip and is easy to install and remove.

Specifications

• Part Number: 127154
• Brand: Hypertherm
• Material: Steel
• Finish: Knurled
• Weight: 0.5 ounces
• Dimensions: 1.0" OD x 0.5" H

Compatibility

The Hypertherm 127154 drive nut is compatible with the following Hypertherm plasma cutting systems:

• Powermax30 XP
• Powermax45 XP
• Powermax65 XP
• Powermax85 XP
• Powermax105 XP
• Powermax125 XP

Installation

To install the Hypertherm 127154 drive nut, follow these steps:

1. Disconnect the power supply from the plasma cutting system.
2. Remove the old drive nut from the lead screw.
3. Clean the lead screw with a solvent to remove any dirt or debris.
4. Apply a small amount of grease to the lead screw.
5. Thread the new drive nut onto the lead screw.
6. Tighten the drive nut until it is snug.
7. Reconnect the power supply to the plasma cutting system.

Maintenance

The Hypertherm 127154 drive nut should be inspected regularly for wear and tear. If the drive nut is damaged, it should be replaced immediately. To extend the life of the drive nut, it should be cleaned and lubricated regularly.

Troubleshooting

If the Hypertherm 127154 drive nut is not working properly, it may be due to one of the following issues:

• The drive nut is not properly installed.
• The drive nut is damaged.
• The lead screw is damaged.
• The plasma cutting system is not properly calibrated.

If you are experiencing problems with the Hypertherm 127154 drive nut, please contact Hypertherm technical support for assistance.