Hypertherm 228447 KIT:Hard Drive 250 GB SATAfor EDGE PRO with latest Phoenix software

Product Description

The Hypertherm 228447 KIT:Hard Drive 250 GB SATAfor EDGE PRO with latest Phoenix software is a hard drive kit that includes a 250 GB SATA hard drive and the latest Phoenix software. This kit is designed for use with the Hypertherm EDGE PRO plasma cutting system.

The 250 GB SATA hard drive provides ample storage space for your cutting files and projects. The latest Phoenix software offers a variety of features and improvements, including:

• A new user interface that makes it easier to find and use the features you need
• Improved cutting performance, with faster cut speeds and better edge quality
• New features, such as the ability to create and save custom cut programs

Specifications

• Hard Drive Capacity: 250 GB
• Interface: SATA
• Software: Phoenix
• Compatibility: Hypertherm EDGE PRO plasma cutting system

Installation

To install the Hypertherm 228447 KIT:Hard Drive 250 GB SATAfor EDGE PRO with latest Phoenix software, follow these steps:

1. Power off the Hypertherm EDGE PRO plasma cutting system.
2. Open the side panel of the system.
3. Locate the hard drive bay.
4. Remove the existing hard drive, if necessary.
5. Insert the new 250 GB SATA hard drive into the hard drive bay.
6. Connect the SATA data cable and power cable to the hard drive.
7. Close the side panel of the system.
8. Power on the Hypertherm EDGE PRO plasma cutting system.
9. Follow the on-screen instructions to install the Phoenix software.

Troubleshooting

If you experience any problems with the Hypertherm 228447 KIT:Hard Drive 250 GB SATAfor EDGE PRO with latest Phoenix software, please refer to the following troubleshooting tips:

• Check the connections between the hard drive and the system.
• Make sure that the hard drive is properly formatted.
• Reinstall the Phoenix software.
• Contact Hypertherm technical support for assistance.

Conclusion

The Hypertherm 228447 KIT:Hard Drive 250 GB SATAfor EDGE PRO with latest Phoenix software is a valuable upgrade for your Hypertherm EDGE PRO plasma cutting system. This kit provides increased storage capacity, improved cutting performance, and new features. Installation is simple and straightforward. If you experience any problems, please refer to the troubleshooting tips provided.