Monthly Basis
What's happening this month?

Hypertherm 123059 Interface Cable

Overview

The Hypertherm 123059 Interface Cable is a 15-foot cable that connects the SA control panel to the current control. It is used to control the current output of the plasma cutter.

Specifications

  • Length: 15 feet
  • Connector Type: DB-25
  • Pin Configuration: 1-1, 2-2, 3-3, 4-4, 5-5, 6-6, 7-7, 8-8, 9-9, 10-10, 11-11, 12-12, 13-13, 14-14, 15-15, 16-16, 17-17, 18-18, 19-19, 20-20, 21-21, 22-22, 23-23, 24-24, 25-25

Installation

To install the Hypertherm 123059 Interface Cable, follow these steps:

  1. Turn off the plasma cutter.
  2. Disconnect the existing interface cable from the SA control panel and the current control.
  3. Connect the Hypertherm 123059 Interface Cable to the SA control panel and the current control.
  4. Turn on the plasma cutter.

Troubleshooting

If you are experiencing problems with the Hypertherm 123059 Interface Cable, check the following:

  • Make sure that the cable is properly connected to the SA control panel and the current control.
  • Check the cable for any damage.
  • Try replacing the cable with a new one.

If you are still experiencing problems, contact Hypertherm Technical Support for assistance.

Conclusion

The Hypertherm 123059 Interface Cable is a reliable and easy-to-use cable that is essential for controlling the current output of the plasma cutter. It is a high-quality cable that is built to last.

Similar Parts

123118
Interface cable for arc writer, control panel SA for current control, 75 ft.

123116
Interface cable for arc writer, control panel SA for current control

084005
Arc Writer Power Supply with control panel SA for current control, 480v, 60 hz, 3 phase

084019
ArcWriter Power Supply with Control Panel SA for current control and Voltage Divider Boa...

084026
Power Supply w/control panel SA for current control

101043
PANEL:THC CONTROL INTERFACE FRONT

004147
Electrode Gauge; used to check electrode life

420045
SHIELD: 9430 200A AIR HYSPEED CONSUMABLES This shield is to be used with the MAXPro no...

229671
POWER SOURCE:ALTERNATING CURRENT TO DIRECT CURRENT CONVERTER 100-240 VOLTS ALTERNATING C...

023874
Cable Between PS and Remote Current Control Cable - PS/RCC, 75 ft.