Hypertherm 120979 PowerMax 1250 Deflector

Product Description

The Hypertherm 120979 PowerMax 1250 Deflector is a replacement part for the Hypertherm PowerMax 1250 plasma cutting system. The deflector is used to direct the flow of plasma gas and protect the torch from damage.

Specifications

• Brand: Hypertherm
• Part number: 120979
• Description: PowerMax 1250 Deflector
• Material: Copper
• Dimensions: 2.5" x 1.5" x 0.5"
• Weight: 0.5 lbs.

Features

• Made from durable copper for long life
• Easy to install and replace
• Helps to protect the torch from damage
• Improves cutting performance

Applications

The Hypertherm 120979 PowerMax 1250 Deflector is used in the following applications:

• Plasma cutting
• Metal fabrication
• Automotive repair
• Construction

Installation

The Hypertherm 120979 PowerMax 1250 Deflector can be installed by following these steps:

1. Turn off the power to the plasma cutting system.
2. Remove the old deflector from the torch.
3. Install the new deflector onto the torch.
4. Tighten the deflector screws.
5. Turn on the power to the plasma cutting system.

Maintenance

The Hypertherm 120979 PowerMax 1250 Deflector should be inspected regularly for signs of wear or damage. If the deflector is damaged, it should be replaced immediately.

Troubleshooting

If you are experiencing problems with the Hypertherm 120979 PowerMax 1250 Deflector, you can try the following troubleshooting steps:

• Check the deflector for signs of wear or damage.
• Clean the deflector with a mild detergent and water.
• Reinstall the deflector.
• If the problem persists, contact Hypertherm technical support.

Conclusion

The Hypertherm 120979 PowerMax 1250 Deflector is an important part of the Hypertherm PowerMax 1250 plasma cutting system. The deflector helps to protect the torch from damage and improves cutting performance. By following the installation, maintenance, and troubleshooting steps outlined in this document, you can ensure that the deflector is functioning properly.