Hypertherm 027254 PowerMax 1250 Replacement Trigger Spring, T80

Description

The Hypertherm 027254 PowerMax 1250 Replacement Trigger Spring, T80 is a genuine OEM part that is essential for the proper functioning of your Hypertherm PowerMax 1250 plasma cutter. This spring is located in the trigger assembly and is responsible for returning the trigger to its original position after it has been depressed.

Specifications

• Brand: Hypertherm
• Part number: 027254
• Part description: PowerMax 1250 Replacement Trigger Spring, T80
• Material: Steel
• Finish: Zinc-plated
• Dimensions: 0.75" long x 0.187" diameter
• Weight: 0.01 oz

Installation

To install the Hypertherm 027254 PowerMax 1250 Replacement Trigger Spring, T80, follow these steps:

1. Remove the trigger assembly from the plasma cutter.
2. Locate the old trigger spring and remove it.
3. Install the new trigger spring in the trigger assembly.
4. Reinstall the trigger assembly in the plasma cutter.

Troubleshooting

If your Hypertherm PowerMax 1250 plasma cutter is not functioning properly, the trigger spring may be the cause. Here are some troubleshooting tips:

• Check the trigger spring for damage or wear. If the spring is damaged or worn, it will need to be replaced.
• Make sure the trigger spring is installed correctly. The spring should be seated properly in the trigger assembly.
• If the trigger spring is installed correctly and is not damaged, the problem may be with another component of the trigger assembly. In this case, you will need to contact Hypertherm for further assistance.

Conclusion

The Hypertherm 027254 PowerMax 1250 Replacement Trigger Spring, T80 is an essential part for your Hypertherm PowerMax 1250 plasma cutter. By following the installation and troubleshooting tips in this document, you can keep your plasma cutter running smoothly and efficiently.