Hypertherm 003277 Relay

Part Description

The Hypertherm 003277 relay is a 24VDC coil, normally open silver contacts relay with magnetic blowout. It is used in a variety of Hypertherm plasma cutting systems.

Specifications

• Brand: Hypertherm
• Part Number: 003277
• Part Description: RELAY:24 VOLTS DIRECT CURRENT COIL NORMALLY OPEN SILVER CONTACTS WITH MAGNETIC BLOWOUT B...
• Coil Voltage: 24VDC
• Contact Type: Normally Open
• Contact Material: Silver
• Contact Rating: 10A @ 250VAC
• Magnetic Blowout: Yes

Applications

The Hypertherm 003277 relay is used in the following Hypertherm plasma cutting systems:

• Powermax30 XP
• Powermax45 XP
• Powermax65 XP
• Powermax85 XP
• Powermax105 XP
• Powermax125 XP

Installation

The Hypertherm 003277 relay can be installed by following these steps:

1. Disconnect the power to the plasma cutting system.
2. Locate the relay in the plasma cutting system.
3. Remove the old relay.
4. Install the new relay.
5. Reconnect the power to the plasma cutting system.

Troubleshooting

If the Hypertherm 003277 relay is not working, there are a few things you can check:

• Check the coil voltage to make sure it is 24VDC.
• Check the contact continuity to make sure the contacts are closed when the relay is energized.
• Check the magnetic blowout to make sure it is working properly.

If you have checked all of these things and the relay is still not working, you may need to replace it.