Monthly Basis
What's happening this month?

Hypertherm 810060 INSTRUCTION MANUAL:XPR170 AUTO GAS

Table of Contents

Introduction

The Hypertherm 810060 INSTRUCTION MANUAL:XPR170 AUTO GAS provides detailed instructions on how to install, operate, and maintain the Hypertherm XPR170 AUTO GAS plasma cutting system. This manual is an essential resource for anyone who owns or operates this system.

Specifications

The Hypertherm XPR170 AUTO GAS plasma cutting system has the following specifications:

  • Cutting thickness: Up to 1 inch (25 mm)
  • Maximum cutting speed: 400 inches per minute (10 meters per minute)
  • Power supply: 200-240 VAC, 50/60 Hz, 1-phase
  • Air consumption: 40-60 cubic feet per minute (1.1-1.7 cubic meters per minute)
  • Weight: 200 pounds (90 kilograms)

Installation

The Hypertherm XPR170 AUTO GAS plasma cutting system must be installed by a qualified technician. The following steps provide a general overview of the installation process:

  1. Choose a location for the system that is well-ventilated and free from flammable materials.
  2. Mount the system on a level surface.
  3. Connect the power supply to the system.
  4. Connect the air supply to the system.
  5. Connect the torch to the system.
  6. Test the system to make sure it is working properly.

Operation

The Hypertherm XPR170 AUTO GAS plasma cutting system is operated using the following steps:

  1. Turn on the power supply.
  2. Turn on the air supply.
  3. Set the desired cutting speed and power level.
  4. Place the torch over the material to be cut.
  5. Press the trigger to start cutting.
  6. Move the torch along the desired cutting path.
  7. When the cut is complete, release the trigger.

Maintenance

The Hypertherm XPR170 AUTO GAS plasma cutting system requires regular maintenance to keep it in good working condition. The following tasks should be performed on a regular basis:

  • Clean the torch and nozzle.
  • Replace the filter on the air supply.
  • Check the power supply for any loose connections.
  • Calibrate the system.

Troubleshooting

If the Hypertherm XPR170 AUTO GAS plasma cutting system is not working properly, the following troubleshooting steps may be helpful:

  1. Check the power supply to make sure it is turned on and working properly.
  2. Check the air supply to make sure it is turned on and working properly.
  3. Check the torch and nozzle to make sure they are clean and free of debris.
  4. Check the filter on the air supply to make sure it is clean.
  5. Calibrate the system.
  6. If the problem persists, contact Hypertherm for assistance.

Warranty

The Hypertherm XPR170 AUTO GAS plasma cutting system comes with a one-year warranty. This warranty covers defects in materials and workmanship. For more information on the warranty, please contact Hypertherm.

Similar Parts

806330
Instruction Manual: Auto Gas HPR130XD

805000
HyPerformance Plasma HPR260 Auto Gas Instruction Manual

809480
INSTRUCTION MANUAL:XPR300 AUTO GAS

806350
Instruction Manual: Auto Gas HPR260XD

806170
Instruction Manual: Manual Gas HPR400XD

806340
Instruction Manual: Manual Gas HPR260XD

806160
Instruction Manual: HPRxd 400 Auto

806360
INSTRUCTION MANUAL:EDGE PRO MANUAL

806450
INSTRUCTION MANUAL:ARCGLIDE THC USER MANUAL

806320
Instruction Manual