Hypertherm 228493 KIT:EDGE PRO SERIAL CONNECTOR

Product Description

The Hypertherm 228493 KIT:EDGE PRO SERIAL CONNECTOR is a genuine Hypertherm replacement part.

Compatibility

The Hypertherm 228493 KIT:EDGE PRO SERIAL CONNECTOR is compatible with the following Hypertherm systems:

• Powermax30 XP
• Powermax45 XP
• Powermax65 XP
• Powermax85 XP
• Powermax105 XP
• Powermax125 XP

Installation

The Hypertherm 228493 KIT:EDGE PRO SERIAL CONNECTOR can be installed by following these steps:

1. Disconnect the power supply from the plasma cutter.
2. Remove the side panel of the plasma cutter.
3. Locate the serial connector on the plasma cutter's circuit board.
4. Remove the old serial connector from the circuit board.
5. Install the new serial connector on the circuit board.
6. Replace the side panel of the plasma cutter.
7. Reconnect the power supply to the plasma cutter.

Troubleshooting

If you are experiencing problems with the Hypertherm 228493 KIT:EDGE PRO SERIAL CONNECTOR, you can try the following troubleshooting steps:

• Check the connection between the serial connector and the circuit board.
• Make sure that the serial connector is properly seated in the circuit board.
• Try using a different serial connector.
• If you are still experiencing problems, contact Hypertherm technical support for assistance.

Conclusion

The Hypertherm 228493 KIT:EDGE PRO SERIAL CONNECTOR is a genuine Hypertherm replacement part that is compatible with a variety of Hypertherm plasma cutters. The part can be installed by following a few simple steps, and troubleshooting steps are available if you experience any problems.