Hypertherm 229829

Description

The Hypertherm 229829 is an assembly that includes the following components:

• 223478 Plasma Interface EtherCAT HPR PCB
• Cable adapter

The assembly is used to connect a Hypertherm plasma cutter to an EtherCAT network.

Specifications

The 229829 assembly has the following specifications:

• Dimensions: 10" x 8" x 4"
• Weight: 2 lbs.
• Input voltage: 120 VAC
• Output voltage: 24 VDC
• Maximum current: 10 A

Installation

The 229829 assembly can be installed by following these steps:

1. Disconnect the power from the plasma cutter.
2. Remove the side panel from the plasma cutter.
3. Locate the EtherCAT port on the plasma cutter.
4. Connect the cable adapter to the EtherCAT port on the plasma cutter.
5. Connect the other end of the cable adapter to the 223478 Plasma Interface EtherCAT HPR PCB.
6. Replace the side panel on the plasma cutter.
7. Reconnect the power to the plasma cutter.

Operation

The 229829 assembly can be operated by following these steps:

1. Power on the plasma cutter.
2. Open the EtherCAT configuration software.
3. Create a new EtherCAT network.
4. Add the 229829 assembly to the EtherCAT network.
5. Configure the 229829 assembly.
6. Save the EtherCAT network configuration.
7. Power cycle the plasma cutter.

The 229829 assembly is now ready to use.

Similar Parts

428447
HPR400XD ETHERCAT ADAPTER KIT EtherCat PCB, VDC3, Wire Harness, Etc....

223478
CABLE:HPR INTERFACE ETHERCAT ADAPTER

428489
KIT:HPR130/260 INTERFACE ETHERCAT ADAPTER

104425
ADAPTER:HPR MET CONSOLE II PLASMA

029514
HT-2000 I/O PCB PCB-8

228576
KIT:PRINTED CIRCUIT BOARD ASSEMBLY PLASMA INTERFACE

128408
KIT: C THC Plasma Intrface PCB

223363
CABLE:DB-15 PLASMA INTERFACE 22.86 m 75 ft

223361
CABLE:DB-15 PLASMA INTERFACE 10.66 m 35 ft

223104
Cable Plasma I/O THC Control Interface 100'