Hypertherm 229214 TB1 Input-Power Subassembly

Description

The Hypertherm 229214 TB1 Input-Power Subassembly is a 600V 300A non-grounding block. It is used to connect the input power to the Hypertherm Powermax45XP plasma cutter.

Specifications

Brand: Hypertherm
Part number: 229214
Description: TB1 INPUT-POWER SUBASSEMBLY:600V 300A NON-GROUNDING BLOCK
Input voltage: 208-240 VAC, 50/60 Hz
Input current: 300 A
Output voltage: 208-240 VAC, 50/60 Hz
Output current: 300 A
Dimensions: 6.3" x 4.3" x 2.8" (160 mm x 109 mm x 71 mm)
Weight: 2.2 lb (1 kg)

Features

Non-grounding block
600V 300A capacity
Suitable for use with the Hypertherm Powermax45XP plasma cutter

Applications

The Hypertherm 229214 TB1 Input-Power Subassembly is used to connect the input power to the Hypertherm Powermax45XP plasma cutter. It is also suitable for use with other plasma cutters that require a 600V 300A non-grounding block.

Installation

The Hypertherm 229214 TB1 Input-Power Subassembly is installed by connecting the input power wires to the input terminals and the output power wires to the output terminals. The subassembly is then mounted to the plasma cutter using the provided mounting hardware.

Maintenance

The Hypertherm 229214 TB1 Input-Power Subassembly requires no maintenance. However, it is important to inspect the subassembly regularly for damage or wear. If any damage or wear is found, the subassembly should be replaced immediately.

Troubleshooting

If the Hypertherm 229214 TB1 Input-Power Subassembly is not working properly, the following troubleshooting steps can be performed:

Check the input power wires and output power wires to make sure they are properly connected.
Check the input voltage and output voltage to make sure they are within the specified range.
Check the subassembly for damage or wear.
If the problem persists, contact Hypertherm technical support for assistance.

Conclusion

The Hypertherm 229214 TB1 Input-Power Subassembly is a reliable and durable component that is essential for the proper operation of the Hypertherm Powermax45XP plasma cutter. By following the installation, maintenance, and troubleshooting procedures outlined in this document, you can ensure that the subassembly will provide years of trouble-free service.

Similar Parts

229033
TB1 INP-PWR SA:600V 200A NON-GNDG BLK

029316
TB1 INP-PWR SA:600V 140A GNDG BLK

229821
FAN SUBASSEMBLY:XPR 292 CUBIC FEET PER MINUTE RATING 48 VOLTS DIRECT CURRENT POWER INPUT

229213
INPUT/OUTPUT PANEL SUBASSEMBLY:9427 HPR 4-CHOPPERS

420323
SWIRL RING:XPR 60-80A SST AL/130-170A FUEL/300A SST

228464
KIT:HARNNESS EDGE PRO AC INPUT MODULE

229727
HARNESS:EDGE CONNECT INPUT/OUTPUT

141371
PRINTED CIRCUIT BOARD ASSEMBLY:XPR INPUT/OUTPUT

128277
Mounting block kit for 1-3/8" diameter torch

DINC-0004
DIN Terminal Block