Hypertherm 228737 KIT:M65/M85/M105/MRT POSITIONING SLEEVE

Product Description

The Hypertherm 228737 KIT:M65/M85/M105/MRT POSITIONING SLEEVE is a positioning sleeve kit that is used with the following Hypertherm plasma cutting torches:

• M65
• M85
• M105
• MRT

The kit includes the following components:

• 1 x Positioning Sleeve
• 1 x Screw
• 1 x Washer

Installation Instructions

To install the positioning sleeve, follow these steps:

1. Remove the old positioning sleeve from the torch.
2. Clean the torch body where the positioning sleeve will be installed.
3. Apply a small amount of grease to the new positioning sleeve.
4. Insert the positioning sleeve into the torch body.
5. Secure the positioning sleeve with the screw and washer.

Safety Precautions

When working with plasma cutting torches, it is important to take the following safety precautions:

• Wear proper protective clothing, including gloves, eye protection, and a face shield.
• Ensure that the torch is properly grounded.
• Keep the torch away from flammable materials.
• Do not touch the torch tip or electrode with your bare hands.
• Allow the torch to cool down before handling it.

Troubleshooting

If you are experiencing problems with the positioning sleeve, check the following:

• Make sure that the positioning sleeve is properly installed.
• Make sure that the screw and washer are tight.
• Clean the positioning sleeve and torch body.
• If the problem persists, contact Hypertherm technical support.

Conclusion

The Hypertherm 228737 KIT:M65/M85/M105/MRT POSITIONING SLEEVE is a genuine Hypertherm replacement part. It is made to the same high quality standards as the original part, and it is backed by Hypertherm's warranty.