Hypertherm 220635 HPR/Nozzle Retaining Cap

Product Description

The Hypertherm 220635 HPR/Nozzle Retaining Cap is a genuine Hypertherm replacement part for HPR plasma cutting torches. This cap is used to retain the nozzle in place and ensure proper alignment of the plasma arc. The 220635 cap is made of durable carbon steel and is rated for use with 400 amp cutting currents.

Specifications

• Brand: Hypertherm
• Part number: 220635
• Part description: HPR/Nozzle Retaining Cap/400 Amp/Carbon Steel
• Material: Carbon steel
• Current rating: 400 amps

Compatibility

The Hypertherm 220635 HPR/Nozzle Retaining Cap is compatible with the following Hypertherm plasma cutting torches:

• HPR130XD
• HPR260XD
• HPR400XD
• HPR600XD
• HPR800XD
• HPR1000XD

Installation

To install the Hypertherm 220635 HPR/Nozzle Retaining Cap, follow these steps:

1. Remove the old nozzle retaining cap.
2. Clean the nozzle and the torch body.
3. Apply a small amount of anti-seize compound to the threads of the new nozzle retaining cap.
4. Screw the new nozzle retaining cap onto the torch body.
5. Tighten the nozzle retaining cap until it is snug.

Maintenance

The Hypertherm 220635 HPR/Nozzle Retaining Cap should be inspected regularly for signs of wear or damage. If the cap is damaged, it should be replaced immediately. To extend the life of the nozzle retaining cap, it should be cleaned after each use.

Troubleshooting

If you are experiencing problems with your Hypertherm plasma cutting torch, the nozzle retaining cap may be the cause. Check the cap for signs of wear or damage. If the cap is damaged, it should be replaced. If the cap is not damaged, clean the cap and the torch body. If the problem persists, contact Hypertherm technical support for assistance.

Warranty

The Hypertherm 220635 HPR/Nozzle Retaining Cap is covered by a one-year warranty. For more information, please refer to the Hypertherm warranty policy.