The Hypertherm PowerMax 1250 Mounting Sleeve Replacement is a genuine OEM part that is designed to replace the worn or damaged mounting sleeve on your PowerMax 1250 plasma cutter. This part is made from durable materials and is built to last. It is easy to install and will help to ensure that your plasma cutter is operating properly.
Turn off the power to your plasma cutter and disconnect the power cord.
Locate the mounting sleeve on the front of your plasma cutter.
Using a wrench, loosen the two screws that hold the mounting sleeve in place.
Remove the old mounting sleeve and discard it.
Place the new mounting sleeve in place and tighten the two screws.
Reconnect the power cord and turn on your plasma cutter.
803940
PowerMax 1250 PowerMax 1250 Service Manual
087013
PowerMax 1250 PowerMax 1250 with 50' leads
803950
PowerMax 1250 PowerMax 1250 Operator's Manual
128638
PowerMax 1250 Kit: ETR Connection Replacement
128644
PowerMax 1250 T80 Torch Handle Replacement Kit
128642
PowerMax 1250 Kit: T80 Start Switch Replacement
128641
PowerMax 1250 Kit: Torch Leads, T80 M, replacement
011093
PowerMax 1250 Replacement Filter Element for STD Filter
011092
PowerMax 1250 Replacement Filter Element for Gas Filter Bowl
027684
PowerMax 1250 Replacement Bushing for Circle Cutting Guide Assembly