Hypertherm 123865 Ignition Control Cable

Part Description

The Hypertherm 123865 Ignition Control Cable is a 7-foot cable that connects the torch to the power supply. It is used to control the ignition of the plasma arc. The cable is made of a durable, flexible material that is resistant to heat and chemicals. It has a quick-disconnect fitting on one end and a male connector on the other end.

Specifications

• Length: 7 feet
• Material: Durable, flexible material
• Resistant to heat and chemicals
• Quick-disconnect fitting on one end
• Male connector on the other end

Applications

The Hypertherm 123865 Ignition Control Cable is used with Hypertherm plasma cutters. It is compatible with the following models:

• Powermax30XP
• Powermax45XP
• Powermax65XP
• Powermax85XP
• Powermax105XP
• Powermax125XP

Installation

To install the Hypertherm 123865 Ignition Control Cable, follow these steps:

1. Disconnect the power supply from the torch.
2. Remove the old ignition control cable from the torch.
3. Connect the new ignition control cable to the torch.
4. Reconnect the power supply to the torch.

Troubleshooting

If you are having problems with the Hypertherm 123865 Ignition Control Cable, check the following:

• Make sure that the cable is properly connected to the torch and the power supply.
• Check the cable for damage.
• If the cable is damaged, replace it with a new one.

If you are still having problems, contact Hypertherm Technical Support for assistance.