Hypertherm 120913 Swirl Ring, O2, 300 Amp

Description

The Hypertherm 120913 Swirl Ring, O2, 300 Amp is a genuine Hypertherm replacement part. This swirl ring is used in Hypertherm plasma cutting torches to create a swirling motion of the plasma gas, which helps to improve cut quality and reduce dross.

Specifications

• Brand: Hypertherm
• Part number: 120913
• Part description: Swirl Ring, O2, 300 Amp
• Material: Copper
• Dimensions: 1.0" OD x 0.75" ID x 0.25" H

Compatibility

The Hypertherm 120913 Swirl Ring, O2, 300 Amp is compatible with the following Hypertherm plasma cutting torches:

• Powermax300
• Powermax300XP
• Powermax45XP
• Powermax65
• Powermax85
• Powermax105
• Powermax125

Installation

To install the Hypertherm 120913 Swirl Ring, O2, 300 Amp, follow these steps:

1. Remove the old swirl ring from the plasma cutting torch.
2. Clean the area around the swirl ring seat.
3. Apply a small amount of anti-seize compound to the new swirl ring.
4. Screw the new swirl ring into the plasma cutting torch.
5. Tighten the swirl ring until it is snug.

Maintenance

The Hypertherm 120913 Swirl Ring, O2, 300 Amp should be inspected regularly for wear and tear. If the swirl ring is damaged, it should be replaced immediately.

Troubleshooting

If you are experiencing problems with your Hypertherm plasma cutting torch, the swirl ring may be the cause. Check the swirl ring for damage and replace it if necessary.

Conclusion

The Hypertherm 120913 Swirl Ring, O2, 300 Amp is an important part of your Hypertherm plasma cutting torch. By following these tips, you can ensure that your swirl ring is properly installed and maintained, which will help you to achieve optimal cut quality.