Hypertherm 120677 Swirl Ring, 30A MS

Part Information

Brand: Hypertherm Part Number: 120677 Description: Swirl Ring, 30A MS

Compatibility

This swirl ring is compatible with the following Hypertherm plasma cutters:

• Powermax30 XP
• Powermax30 AIR
• Powermax45 XP
• Powermax45 AIR
• Powermax65 XP
• Powermax65 AIR
• Powermax85 XP
• Powermax85 AIR
• Powermax105 XP
• Powermax105 AIR
• Powermax125 XP
• Powermax125 AIR

Features

• This swirl ring is made of durable copper material.

Installation

To install this swirl ring, follow these steps:

1. Disconnect the plasma cutter from the power source.
2. Remove the old swirl ring from the plasma torch.
3. Install the new swirl ring on the plasma torch.
4. Tighten the swirl ring until it is snug.
5. Reconnect the plasma cutter to the power source.

Safety Precautions

When working with plasma cutters, always follow these safety precautions:

• Wear protective clothing, including gloves, eye protection, and a face shield.
• Do not touch the plasma torch or the workpiece while the plasma cutter is in operation.
• Keep the plasma cutter away from flammable materials.
• Ventilate the area well to remove fumes.

Troubleshooting

If you are experiencing problems with your plasma cutter, refer to the following troubleshooting tips:

• Check the swirl ring for damage. If the swirl ring is damaged, replace it with a new one.
• Check the swirl ring for proper installation. Make sure the swirl ring is installed correctly and is tightened until it is snug.
• Check the plasma torch for damage. If the plasma torch is damaged, replace it with a new one.
• Check the power source for proper voltage. Make sure the power source is providing the correct voltage for the plasma cutter.
• Check the ground connection. Make sure the ground connection is clean and tight. If you are still experiencing problems, contact Hypertherm technical support for assistance.