Hypertherm 081061
Part Description
CTHC Firmware Chip RTP
Compatibility
This firmware chip is compatible with the following Hypertherm plasma cutters:
- Powermax30 XP
- Powermax45 XP
- Powermax65 XP
- Powermax85 XP
- Powermax105 XP
- Powermax125 XP
Installation
To install the firmware chip, follow these steps:
- Power off the plasma cutter.
- Remove the side panel of the plasma cutter.
- Locate the CTHC firmware chip.
- Remove the old firmware chip.
- Install the new firmware chip.
- Replace the side panel of the plasma cutter.
- Power on the plasma cutter.
Troubleshooting
If you experience any problems with the firmware chip, please contact Hypertherm technical support.
Similar Parts
081062
CTHC Firmware Chip IOP
228424
HPR 400XD firmware upgrade
228527
KIT:HPR400XD AUTO FIRMWARE UPGRADE