Hypertherm 041706 Command THC Control Board

Description

The Hypertherm 041706 Command THC Control Board is an upgraded board that must be ordered with KIT#128407. This board provides improved performance and reliability over the previous version.

Features

• Improved THC control
• Increased reliability
• Upgraded components

Specifications

• Input voltage: 24 VDC
• Output voltage: 0-10 VDC
• Output current: 2 A
• Dimensions: 3.5" x 2.5" x 1.0"

Installation

The Hypertherm 041706 Command THC Control Board can be installed by following these steps:

1. Disconnect the power supply from the plasma cutter.
2. Remove the old THC control board.
3. Install the new THC control board.
4. Reconnect the power supply to the plasma cutter.
5. Power on the plasma cutter and verify that the THC control board is functioning properly.

Troubleshooting

If you are experiencing problems with the Hypertherm 041706 Command THC Control Board, please refer to the following troubleshooting steps:

1. Check the input voltage and output voltage to make sure they are within specifications.
2. Check the output current to make sure it is within specifications.
3. Check the connections between the THC control board and the plasma cutter to make sure they are secure.
4. If the problem persists, contact Hypertherm technical support for assistance.

Conclusion

The Hypertherm 041706 Command THC Control Board is an upgraded board that provides improved performance and reliability over the previous version. This board is easy to install and can be used to troubleshoot THC control problems.