Hypertherm 029202 Current Sensor Module

Product Description

The Hypertherm 029202 Current Sensor Module is a component of the Hypertherm Powermax plasma cutting systems. It is responsible for measuring the current flowing through the plasma torch and providing feedback to the control system. The module is located in the control cabinet of the plasma cutting system.

Specifications

• Input voltage: 24 VDC
• Input current: 0-5 A
• Output voltage: 0-5 VDC
• Output current: 0-20 mA
• Accuracy: ±1% of full scale
• Response time: <1 ms

Installation

The Hypertherm 029202 Current Sensor Module is installed in the control cabinet of the plasma cutting system. The module is mounted on a DIN rail. The following steps should be followed to install the module:

1. Turn off the power to the plasma cutting system.
2. Remove the cover from the control cabinet.
3. Locate a free DIN rail slot.
4. Mount the module on the DIN rail.
5. Connect the input and output wires to the module.
6. Replace the cover on the control cabinet.
7. Turn on the power to the plasma cutting system.

Troubleshooting

If the Hypertherm 029202 Current Sensor Module is not functioning properly, the following troubleshooting steps should be followed:

1. Check the input and output wires to make sure they are connected properly.
2. Check the input voltage and current to make sure they are within the specified range.
3. Check the output voltage and current to make sure they are within the specified range.
4. If the module is still not functioning properly, it should be replaced.

Conclusion

The Hypertherm 029202 Current Sensor Module is a critical component of the Hypertherm Powermax plasma cutting systems. It is responsible for measuring the current flowing through the plasma torch and providing feedback to the control system. By following the installation and troubleshooting steps outlined in this document, you can ensure that the module is functioning properly and that your plasma cutting system is operating at peak performance.

Similar Parts

228214
Sensor PHC with control module, lifter and 50 foot cable

229671
POWER SOURCE:ALTERNATING CURRENT TO DIRECT CURRENT CONVERTER 100-240 VOLTS ALTERNATING C...

109004
Current Sensor; HALL 100A=4V

428081
KIT:ARCGLIDE AMPLIFIER DC SERVO MODULE

ASSY-0191
Assy, SERCOS Processor & Field Interface Module

428453
KIT:LASER POINTER LIFTER DIODE MODULE S-THC

428008
KIT:AMPLIFIER DC SERVO MODULE

228573
Replacement part - Arc Glide Control Module

228464
KIT:HARNNESS EDGE PRO AC INPUT MODULE

053018
THC Control Module