Hypertherm 020789 Swirl Ring

Product Description

The Hypertherm 020789 swirl ring is a genuine replacement part for Hypertherm HD3070 plasma cutters. This 70 amp swirl ring is designed to create a swirling motion of the plasma gas, which helps to improve cut quality and reduce dross formation.

Specifications

• Brand: Hypertherm
• Part number: 020789
• Part description: 70 amp swirl ring, Hypertherm HD3070
• Material: Copper
• Dimensions: 1.125" OD x 0.875" ID x 0.250" thick
• Weight: 0.25 lbs

Compatibility

The Hypertherm 020789 swirl ring is compatible with the following Hypertherm plasma cutters:

• Hypertherm HD3070

Installation

To install the Hypertherm 020789 swirl ring, simply remove the old swirl ring from the plasma torch and replace it with the new one. Be sure to tighten the swirl ring securely to prevent it from coming loose during operation.

Maintenance

The Hypertherm 020789 swirl ring should be inspected regularly for signs of wear or damage. If the swirl ring is damaged, it should be replaced immediately to prevent damage to the plasma torch.

Troubleshooting

If you are experiencing problems with your Hypertherm plasma cutter, the swirl ring may be the cause. Check the swirl ring for signs of wear or damage, and replace it if necessary.

Conclusion

The Hypertherm 020789 swirl ring is an important part of the plasma cutting process. By keeping the swirl ring clean and in good condition, you can help to ensure optimal cut quality and reduce the risk of damage to your plasma torch.