Monthly Basis
What's happening this month?

Hypertherm 020048 Swirl Ring for PAC 500

Product Description

The Hypertherm 020048 Swirl Ring for PAC 500 is a genuine Hypertherm replacement part.

Specifications

  • Brand: Hypertherm
  • Part number: 020048
  • Part description: Swirl Ring for PAC 500
  • Material: Stainless steel
  • Dimensions: 1.5" OD x 1.125" ID x 0.375" H

Features

  • Improves cutting performance
  • Extends the life of your torch
  • Easy to install

Compatibility

The Hypertherm 020048 Swirl Ring is compatible with the following Hypertherm plasma cutters:

  • PAC 500

Installation

To install the Hypertherm 020048 Swirl Ring, follow these steps:

  1. Turn off the power to your plasma cutter.
  2. Remove the old swirl ring from the torch body.
  3. Clean the torch body and the new swirl ring with a solvent.
  4. Apply a small amount of anti-seize compound to the new swirl ring.
  5. Thread the new swirl ring onto the torch body.
  6. Tighten the swirl ring until it is snug.
  7. Turn on the power to your plasma cutter.

Troubleshooting

If you are experiencing problems with your Hypertherm plasma cutter, the swirl ring may be the cause. Here are some troubleshooting tips:

  • Check the swirl ring for damage. If the swirl ring is damaged, it will need to be replaced.
  • Make sure the swirl ring is properly installed. The swirl ring should be threaded onto the torch body until it is snug.
  • Clean the swirl ring and the torch body with a solvent. A dirty swirl ring can cause problems with cutting performance.
  • If you are still experiencing problems, contact Hypertherm customer service for assistance.

Conclusion

The Hypertherm 020048 Swirl Ring for PAC 500 is a genuine Hypertherm replacement part that is essential for maintaining the performance of your plasma cutter. By following the installation and troubleshooting tips in this document, you can ensure that your plasma cutter is operating at its best.

Similar Parts

020040
Swirl Ring: PAC 500 .220

020030
Pac 500 torch body

040237
SCR Phase Control for PAC 500/H601 Power Supply 800A 1400V

037169
Disc Capacitor for PAC 500/H601 Power Supply H401 .01UF 1000 VDC CER

028031
Pac-500 Torch Head Complete

020047
Nozzle for PAC 500

020037
Nozzle for PAC 500 .220

020043
Ret. Cap: PAC 500

020041
2" torch sleeve for the Max 200 / HT2000 / Pac 500 Plasma systems

020038
Electrode for PAC 500