Hypertherm 011073 Pressure Regulator

Part Description

The Hypertherm 011073 is a pressure regulator for PowerMax 900 900 plasma cutters. It has a pressure range of 0-125 psi and a 1/4" NPT connection.

Features

Pressure range: 0-125 psi
Connection: 1/4" NPT
For use with PowerMax 900 900 plasma cutters

Benefits

Regulates the pressure of the plasma gas
Ensures consistent cutting performance
Prolongs the life of the plasma cutter

Applications

The Hypertherm 011073 pressure regulator is ideal for use with PowerMax 900 900 plasma cutters. It can be used for a variety of cutting applications, including:

Mild steel
Stainless steel
Aluminum
Copper

Installation

The Hypertherm 011073 pressure regulator can be easily installed by following these steps:

Turn off the power to the plasma cutter.
Disconnect the plasma gas hose from the plasma cutter.
Connect the pressure regulator to the plasma cutter.
Connect the plasma gas hose to the pressure regulator.
Turn on the power to the plasma cutter.

Maintenance

The Hypertherm 011073 pressure regulator requires minimal maintenance. However, it is important to inspect the regulator for any signs of damage or wear. If the regulator is damaged or worn, it should be replaced immediately.

Troubleshooting

If the pressure regulator is not working properly, there are a few things you can check:

Make sure that the regulator is properly installed.
Check the pressure gauge to make sure that the pressure is set correctly.
Check the plasma gas hose for any leaks.
If the regulator is still not working properly, you may need to replace it.

Similar Parts

011114
Filter/regulator:7-125 PSI 1/4 auto drain w gauge

011025
Filter/Regulator, 0-120 PSI, 1/4 NPT Air

005233
PS2 - Switch, pressure, 0-90 psi

005235
60 psi pressure switch, descending

005239
26 PSI Assending Pressure Switch

128801
Pressure Regulator

128659
Pressure Transducer for PowerMax 1650

128384
Kit: pump w/CLP 70 GPH 200 psi

129994
Pump Assembly, 70 GPM, 200 PSI for HPR 130

128547
KIT:2-STG AIR RGLTR 250 PSI